What Clients Say about us..


ALL SYSTEMS HEATING AND COOLING
Bosch Mini-Split Installation in Shokan, NY
Bosch mini-split installation in Shokan includes sizing your home with a Manual J load calculation, running refrigerant lines and electrical hookup, and commissioning the system to manufacturer specifications. All Systems is a Bosch Gold Pro dealer, meaning every installation comes with a 10-year parts and labor warranty instead of the standard 5-year. We handle single-zone and multi-zone configurations for any room in your Ulster County home.


Why Choose All Systems for Bosch Mini-Split Installation in Shokan
Our Bosch mini-split installation process starts with a detailed load calculation to determine the exact heating and cooling capacity your home needs. We evaluate your insulation, window size and orientation, air leakage, and occupancy patterns to size the system properly. Undersized systems run constantly and waste energy. Oversized systems cycle on and off, reducing efficiency and lifespan. / Once sizing is confirmed, we run refrigerant lines through exterior walls and install the indoor air handler in your chosen location. Electrical work includes a dedicated circuit breaker, thermostat wiring, and a disconnect switch. We vacuum the refrigerant lines to remove moisture, then charge the system to the correct amount. Any moisture left in the lines causes acid buildup and compressor failure. / After installation, we test airflow across the indoor coil, verify refrigerant pressures on both high and low sides, program the thermostat, and run the system through heating and cooling cycles to confirm operation. We clean up all debris and leftover materials before we leave. The entire process for a single-zone system takes one business day. Multi-zone installations take two days.

Load Calculation for Proper Sizing
We perform a Manual J load calculation specific to your home rather than guessing based on square footage. This identifies the exact BTU capacity you need for each zone. Oversized systems waste energy and fail prematurely. Undersized systems struggle to reach setpoint. Proper sizing extends equipment lifespan and keeps utility bills in line.

Refrigerant Line Evacuation and Charging
Moisture inside refrigerant lines causes acid formation and compressor damage. We vacuum the lines to remove all air and water, then charge the system to the manufacturer-specified amount. Incorrect charge pressure reduces heating and cooling capacity by up to 30 percent and increases compressor wear.

System Commissioning and Testing
After installation, we test airflow, verify refrigerant pressures on both sides, confirm thermostat operation, and run full heating and cooling cycles. Every system leaves our job site tested and ready to operate at design efficiency. No surprises later.

Get in touch with us
Fill In your information below


ABOUT
ALL SYSTEMS HEATING & COOLING
who we are
All Systems Heating & Cooling is a local family-owned & operated HVAC company based in Poughkeepsie, NY. For over 20 years, serving Dutchess County and the greater Hudson Valley with reliable heating and cooling work. Handling installation, maintenance, and repair for homes and small businesses.
WHY Shokan PROPERTY OWNERS CHOOSE US
Licensed & Insured ⛨
20+ Years In Business ◷
100+ Satisfied Clients